I have a ps3 that's had the ylod 2 time . tried to reflow it with flux and without flux it worked for 5-10 mins and then ylod. so Im trying to reball it and I got the rsx/gpu off . now on the motherboard there are some solder pads that the solder is not soldering too. I take it that I must of rubbed them off with the deslodering wick . I would like to know if there is any way to fix it or not I hope there is but if not you know what they say "you learn for your mistakes" thanks for any help that anyone can pass over .
ps. there is a pic. I don't know if u can see it that good. but there is a small look like hole where the pad should be.
don't know if the solder iron is hot enough but I don't want to burn the board up trying to get the solder to stick to it.
once again thanks for any help
ps. there is a pic. I don't know if u can see it that good. but there is a small look like hole where the pad should be.
don't know if the solder iron is hot enough but I don't want to burn the board up trying to get the solder to stick to it.
once again thanks for any help