Hi,
I have:
PS3 Phat CECHH04 (NOR)
OFW 4.31
E3 Flasher Limited (Clip - not soldering)
And was following "Ultimate Fool Proof Guide: Ps3 Hardware Downgrading", by Bailay's, to get my PS3 downgraded to OFW 3.55
It happens that during the process I seem to have bricked my PS3 as when I turn it on it goes into the Red Light of Dead mode. Light goes Green, green and red and then blinking red, and the E3 Flasher control board goes out of power.
This started after the downgrade step. one-key downgrade failed so I moved to FlowRebuilder patching & flashing. Once this was completed I restarted the PS3 to move to "Finishing the down grade in service mode", but... now I'm stuck.
So, I'd like to know if the community has any ideas to resolve this?
My investigation didn't bring me to any conclusion about the question if I can resolve this with E3 Flasher or if I have to use ProgSkeet as describer in "Updated your f/w now you get the Flashing Red Light Of Death?" section.
Thank you in advance.
I have:
PS3 Phat CECHH04 (NOR)
OFW 4.31
E3 Flasher Limited (Clip - not soldering)
And was following "Ultimate Fool Proof Guide: Ps3 Hardware Downgrading", by Bailay's, to get my PS3 downgraded to OFW 3.55
It happens that during the process I seem to have bricked my PS3 as when I turn it on it goes into the Red Light of Dead mode. Light goes Green, green and red and then blinking red, and the E3 Flasher control board goes out of power.
This started after the downgrade step. one-key downgrade failed so I moved to FlowRebuilder patching & flashing. Once this was completed I restarted the PS3 to move to "Finishing the down grade in service mode", but... now I'm stuck.
So, I'd like to know if the community has any ideas to resolve this?
My investigation didn't bring me to any conclusion about the question if I can resolve this with E3 Flasher or if I have to use ProgSkeet as describer in "Updated your f/w now you get the Flashing Red Light Of Death?" section.
Thank you in advance.